Workmanship Standards Manual

topyes

Workmanship Standards Manual，机械工人标准手册E文，感兴趣的不要错过。

topyes

Workmanship Standards Manual
Mechanical Fabrication, Fasteners, & Finishes
Section V -- Mechanical Fabrication, Fasteners, & Finishes
1.0 Scope

1.1. Purpose -- This standard applies to all Mechanical Fabrication, Finishes, and Fasteners assembled for use by Hybricon or by contract vendor. If there is a conflict between the requirements of this standard and the Purchase contract or Engineering drawing, the precedence shall be:

1.2. This section defines the workmanship practices required in the fabrication of sheet metal and the use, assembly sequence, and workmanship requirements associated with mechanical fasteners

2.0 GENERAL

2.1 - Cardcages, mechanical, electro-mechanical subassemblies and panels shall conform to the requirements specified herein or as required by referenced paragraph.

Damage - There shall be no damage beyond the limits specified in applicable sections of this document

2.2 Conflict -- In the event of conflict between this specification and other applicable or referenced documents, the following order of precedence shall apply:

FIRST - Engineering Drawing/Specification
SECOND - Purchasing Contract

Approved Manufacturing Processes
FOURTH - This Standard

2.2 Terminology -- The terms referred to in this section are defined throughout this document and in the Glossary (045-030-07).

2.3 The purpose of this section is to identify minimal acceptable criteria for manufactured mechanical fabricated finishes and including fastening methods.

2.4 All tools and equipment used during the fabrication of these assemblies/methods shall be capable of maintaining total conformance to these Standards.

2.5 Unless otherwise specified, the end products must be in full compliance with the criteria noted within this Standard.

topyes

不过没有翻译，E文好的可以看看,后面还有很多,过段时间再发