模具论坛

 找回密码
 注册

扫一扫,微信登录

QQ登录

只需一步,快速开始

搜索
热搜: 冲压 注塑 求助
    回车查看更多
    论坛可能已存在您要发布的主题帖 关闭
      查看: 2442|回复: 0

      [分享] 空乘安全示范

      [复制链接]
      发表于 2013-1-14 08:03:53 | 显示全部楼层 |阅读模式
       ??DOMO 1
        ??Ladies and gentlemen :
        ??Your cabin attendants have just demonstrated the proper method
        ??of using the life jacket(and oxygen mask.)
        ??Please refer to the emergency instruction card in the seat pocket
        ??for more information.Thank you.
        ??
        ??DOMO 2
        ??Ladies and gentlemen :
        ??For your safety,this aircraft is fully equipped with emergency equipments.
        ??We will explain the location and method of use.There are
        ??eight emergency exits located on the left and right sides respectively.
        ??They are identified by the exit signs.
        ??Life jackets are under your seats.In case of emergency,
        ??put the jacket over your head,then bring the straps from behind
        ??you to the front as the attendant is demonstrating.
        ??Fasten the straps and pull tight. The jacket will be automatically
        ??inflated by pulling the two red tabs at the bottom.
        ??There are two mouth pieces inside the life jacket which can be
        ??used to inflate the vest by blowing air into them.The oxygen masks are
        ??in panel over your head. If there is any change in the pressure,
        ??the masks will fall automatically.The masks are as shown.
        ??When the masks fall,pull one of them to your face.
        ??Cover your nose and mouth then breath normally.
        ??Place the strap over your head to keep the mask in place.
        ??If you have an infant,put your mask on first,then put the infant's mask on.
        ??Each seat is provided wiht seat belts. Please keep them fasted
        ??whenever seated. Just pull the buckle to unfasten them.
        ??Please refer to the emergency instruction card in seat pocket
        ??for more imformation. Thank you.
      您需要登录后才可以回帖 登录 | 注册

      本版积分规则

      关闭

      招聘信息 上一条 /5 下一条

      关闭

      求职信息 上一条 /5 下一条

      关闭

      技术求助 上一条 /5 下一条

      QQ|小黑屋|手机版|模具论坛 ( 浙ICP备15037217号 )

      GMT+8, 2025-6-15 19:34

      Powered by Discuz! X3.4

      © 2001-2013 Comsenz Inc.

      快速回复
      返回顶部
      返回列表
       
      客服电话:0577-61318188
      模具论坛交流群:
      模具论坛交流群
      工作时间:
      08:30-17:30