|
;gear.lsp
(defun grinfo ()
(setq c (getpoint "\n齿轮中心: "))
(setq pc (getpoint "\n节距圆: "))
(setq teeth (getint "\n齿数: "))
(while (< teeth 14) (setq teeth (getint "\n必须至少14个齿: ")))
(while (> teeth 50) (setq teeth (getint "\n必须不超过50个齿: ")))
(while (< teeth 14) (setq teeth (getint "\n必须至少14个齿: ")))
(while (> teeth 50) (setq teeth (getint "\n必须不超过50个齿: ")))
)
(defun calgear ()
(setq d (* 2 (distance c pc))) (setq pc (polar c 0 (/ d 2)))
(setq ang3 2.79248)
(setq ang5 (/ 360.000000 teeth))
(setq wang -0.785385)
(setq wang2 0.785385)
(setq dp (/ teeth d))
(setq ht (/ 0.32 dp))
(setq adm (/ 1.0 dp))
(setq y (* (/ 2.257 dp) 1.0642))
)
(defun drawgear ()
(command "PLINE"
(setq p (polar pc 0 adm))
"a"
"ce"
c
"l"
ht
"l"
(setq p (polar (getvar "lastpoint") ang3 y))
"a"
"ce"
c
"l"
ht
""
)
(SETQ TOP (GETVAR "LASTPOINT"))
(command "MIRROR"
"L"
""
(setq p (polar pc 0 adm))
c
"n"
)
(command "ARRAY"
"w"
(POLAR TOP 4.712389 (* Y 1.5))
(polar TOP 0 Y)
""
"c"
c
ang5
"-360"
"Y"
)
)
(defun C:CL ()
(grinfo)
(setq stdots (getvar "blipmode"))
(setq stech (getvar "cmdecho"))
(setvar "blipmode" 0)
(setvar "cmdecho" 0)
(calgear)
(drawgear)
(setvar "blipmode" stdots)
(setvar "cmdecho" stech)) |
|